Beko BD-300 Uživatelský manuál

Dect PhoneUser ManualBD-300

2. Press the OK button, then press UP/DOWN button to the locations MISSED, RECEIVED, or DIALED calls. 3. Press the OK button, then press UP/DOWN b

Ringer Volume (EXT / INT) You can adjust the ringer volume following the below instruction. 1. Press the MENU button, then press UP/DOWN button to

! If you have turned auto-talk on, do not press the CALL button after you have answered a call by lifting the handset, otherwise, you'll disco

4. Press UP/DOWN button to change the volume 5. Press the OK button to confirm the volume level you chosen Least cost route (LCR) function (Option

2. Press the OK button, the display shows PIN? 3. Key in your PIN number and press the OK button, then UP/DOWN button to the location MAST PIN? 4.

1. Disconnect the power lead from the back of the base unit 2. Press and hold the HANDSET LOCATOR button in the base unit, at the same time connec

Intercom and transfer To make an intercom call 1. Press the INT button 2. Key in the number of the other handset On the other handset's dis

Check the batteries level symbol on the display. If it is low, replace the handset on the base unit or charger pod to recharge the batteries. Swit

You need to subscribe to the Caller Display feature from your service provider. The caller may have withheld their number, or they may be calling

Contents What the symbols mean ...3The Handset and Base Unit...

What the symbols mean Batteries charge level Whenever this shows ‘nearly empty’ ( ), put the handset on the base unit to charge the batteries

In standby mode, press to show phonebook list; Press during programming to move through the menu. Press during a call to change the volume in the

Setting up your telephone Connection and conditions for use You can connect your phone to a direct exchange line (DEL), a line connected to a loc

Installation 1. Choose a suitable site for the handset unit Make sure it is not near to another telephone, nor to other electrical equipme

Important safety information This equipment is not designed for making emergency calls in the event of a power failure. Alternative arrangements s

Making and answering calls To switch the handset ON or OFF  Press and hold the CLEAR button for 2~3 seconds to switch the handset ON /OFF. To ma

To store new number into phonebook 1. Press the OK button, the display shows ADD 2. Press the OK button again, then key in the name and the